PDM32 / PDM08
PDM32 and PDM08 replace a car's fuses and relays with a single, fully monitored power distribution module. AiM states there is much more to them than that.
- Power outputs — PDM32
- 1 with series diode up to 20 A, 3 up to 20 A (high power), 12 up to 15 A (mid power), 12 up to 10 A (low power), 4 up to 35 A (Half Bridge). Total max current: 120 A
- Power outputs — PDM08
- 1 with series diode up to 20 A, 1 up to 25 A, 6 up to 15 A. Total max current: 100 A
- Output protection
- Over voltage, under voltage, over current, over temperature; internal freewheeling diode on PDM08 outputs
- Inputs — PDM32
- 8 analog/digital, 6 digital only, 2 speed
- Inputs — PDM08
- 4 analog/digital, 2 speed
- Dash support
- 5", 6" and 10" TFT displays, fully configurable with RaceStudio 3
- Mirror camera input
- PDM32 only — 2 analog camera inputs, switchable by button or event logic (e.g. reverse gear)
- GPS track database
- 4,000 tracks, automatic lap time calculation
Product details
- ECU protocols
- 1,000+ available
PDM32 and PDM08 distribute power to a vehicle's circuits, taking the place of traditional fuse and relay panels. Housed in an anodised billet aluminium case, each also packs in a full professional datalogger and an internal dash controller, cutting down the wiring harness and giving far more control over the electrical system.
Extra capability includes an ECU connection for reading engine data, onboard datalogging so a separate logger isn't needed, a GPS module for automatic lap times and track position, a dash controller that can drive a 5, 6 or 10-inch display, and — on PDM32 only — a mirror camera input for a reverse-gear view.
Every PDM kit bundles the module itself (power distribution, 4 GB datalogger and dash controller), a 5, 6 or 10-inch dash, and a GPS module for lap timing and position.
PDM32 provides 28 high-side outputs and 4 half-bridge outputs; PDM08 provides 8 high-side outputs. Each output reports open-circuit, short-circuit, over-temperature, over-current and under/over-voltage status, with adjustable inrush current and fault-retry behaviour; outputs can run as PWM with soft start/stop, and a multicolour LED shows whether each one is enabled, active or faulted.
Both units gather and log data from the ECU (over 1,000 supported protocols), digital and analog inputs, GPS position and lap time, expansions, AiM K Keypads or any commercial CAN keypad, every output's current and status, and user-defined math channels; the GPS carries 4,000 tracks and picks the right one automatically, while the internal datalogger records all of it for later review.
Versions
- PDM32 — 28 High Side Outputs + 4 Half Bridge Outputs
- PDM08 — 8 High Side Outputs